158 articles – 1990 Notices  [english version]
HAL : hal-00670507, version 1

Fiche concise  Récupérer au format
Nondissipative Addressing for Time-Division SQUID Multiplexing
Prêle D., Voisin F., Martino J., Piat M., Bréelle E.
IEEE Transactions on Applied Superconductivity 21, 6 (2011) 3652-3654 - http://hal.archives-ouvertes.fr/hal-00670507
Physique/Physique/Instrumentations et Détecteurs
Sciences de l'ingénieur/Electronique
Nondissipative Addressing for Time-Division SQUID Multiplexing
D. Prêle ()1, F. Voisin1, J. Martino1, M. Piat1, E. Bréelle1
1 :  APC - UMR 7164 - AstroParticule et Cosmologie
http://www.apc.univ-paris7.fr/
CNRS : UMR7164 – IN2P3 – Observatoire de Paris – Université Paris VII - Paris Diderot – CEA : DSM/IRFU
APC - UMR 7164, Université Paris Diderot, 10 rue Alice Domon et Léonie Duquet, case postale 7020, F-75205 Paris Cedex 13
France
APC - Cosmologie et Gravitation
Recent and future astronomical instruments are based on a focal plane mapped by a large array of superconducting bolometers. Cryogenic analog multiplexing readout techniques, based on superconducting quantum interference devices (SQUIDs), are currently developed to achieve the readout of large arrays of this kind of low noise background-limited detectors. To effectively reduce the number of cryogenic wires (particularly, SQUID biasing), line/column addressing is currently used in time-division multiplexing, i.e., same biasing is applied to a few SQUIDs (on a line) of different columns. This technique should dramatically increase power consumption if parallel biasing is applied via resistors to isolate each column; the power budget is particularly limited on this kind of front-end cryogenic readout. A design with one transformer per SQUID is also used to read out SQUID biased in series with no excess of consumption and crosstalk. We propose here a new biasing technique using simple surface-mounted capacitors, which is easier to implement. These capacitors are used to parallel bias SQUIDs without additional Joule effect while minimizing crosstalk. However, capacitors do not allow dc biasing and need a current mean value equal to zero to avoid biasing source saturation. We have then tested square current biasing through capacitors on a commercial SQUID. This measurement shows that capacitors are able to proper bias SQUID and then to perform a nondissipative addressing for time-division SQUID multiplexing.
Anglais
11/03/2011

IEEE Transactions on Applied Superconductivity
Publisher Institute of Electrical and Electronics Engineers (IEEE)
ISSN 1051-8223 
internationale
Articles dans des revues avec comité de lecture
29/09/2011
21
6
3652-3654

SQUIDs – Time division multiplexing – Superconducting bolometer – Crosstalk

QUBIC
R&T CNES
Liste des fichiers attachés à ce document : 
PDF
prele_ieee.pdf(651.6 KB)