62 articles – 637 Notices  [english version]
HAL : hal-00632624, version 1

Fiche concise  Récupérer au format
Shear Behavior of AA6061 Aluminum in the Semisolid State Under Isothermal and Nonisothermal Conditions
Giraud E., Suery M., Coret M.
Metallurgical and Materials Transactions A 42A, 11 (2011) 3370-3377 - http://hal.archives-ouvertes.fr/hal-00632624
Chimie/Matériaux
Shear Behavior of AA6061 Aluminum in the Semisolid State Under Isothermal and Nonisothermal Conditions
E. Giraud1, M. Suery2, M. Coret
1 :  LPTA - Laboratoire de Physique Théorique et Astroparticules
http://www.lpta.in2p3.fr/
CNRS : UMR5207 – IN2P3 – Université Montpellier II - Sciences et techniques
Bât 13- 1er Et. - CC 070 Place Eugène Bataillon 34095 MONTPELLIER CEDEX 5
France
2 :  SIMaP - Science et Ingénierie des Matériaux et Procédés
http://simap.grenoble-inp.fr/
CNRS : UMR5266 – Université Joseph Fourier - Grenoble I – Institut National Polytechnique de Grenoble (INPG)
1130 rue de la Piscine, BP 75 38402 Saint Martin D'Hères
France
The shear behavior of a 6061 aluminum alloy was studied in the semisolid state at large solid fractions. The tests were carried out either at constant temperature after partial solidification (i.e., isothermal shear tests) or during solidification at low cooling rate (i.e., nonisothermal shear tests). In isothermal conditions, results show that (1) the mechanical behavior depends on the volume fraction of the solid phase present in the sample at the temperature of the test, (2) there is a critical solid fraction corresponding to the coalescence of the solid grains beyond which shear stress increases very sharply with increasing solid fraction, and (3) the mushy alloy exhibits viscoplastic behavior with a strain-rate-sensitivity parameter close to about 0.17. In nonisothermal conditions, results show that stress increases continuously with decreasing temperature whatever the strain rate. However, at high strain rate, it was observed that cracks developed when the solid fraction approaches 1, leading to a slower stress increase compared to that observed at low strain rate. Finally, modeling of this behavior is carried out by considering a cohesion parameter of the solid phase, which depends on solid fraction and strain rate.
Anglais

Metallurgical and Materials Transactions A
Publisher ASM International
ISSN 1073-5623 
internationale
Articles dans des revues avec comité de lecture
2011
42A
11
3370-3377

GPM2