Skip to Main content Skip to Navigation
Poster communications

The LEBT Chopper for the Spiral 2 Project

Abstract : The Spiral 2 driver uses a slow chopper situated in the common section of the low energy beam transport line to change the beam intensity, to cut off the beam in case of critical loss and to avoid hitting the wheel structure of rotating targets. The device has to work up to 10 kV, 1 kHz repetition frequency rate and its design is based on standard power circuits, custom alarm board and vacuum feed-through. The paper summarizes the design principles and describes the test results of the final device which has been installed on the beam line test bench.
Document type :
Poster communications
Complete list of metadatas

http://hal.in2p3.fr/in2p3-00620771
Contributor : Michel Lion <>
Submitted on : Thursday, October 27, 2011 - 9:31:13 AM
Last modification on : Thursday, February 1, 2018 - 1:32:58 AM
Long-term archiving on: : Sunday, December 4, 2016 - 9:15:09 PM

File

tups082.pdf
Publisher files allowed on an open archive

Identifiers

  • HAL Id : in2p3-00620771, version 1

Collections

Citation

A.C. Caruso, F. Consoli, G. Gallo, D. Rifuggiato, E. Zappalà, et al.. The LEBT Chopper for the Spiral 2 Project. 2nd International Particle Accelerator Conference (IPAC2011), Sep 2011, San Sebastian, Spain. TUPS082, pp.1731-1733, 2011. ⟨in2p3-00620771⟩

Share

Metrics

Record views

265

Files downloads

348